Preparing the Saw Stand

Before securing the holder set and the power tool, you must pull the base unit apart.

To release the lock bolts (20), gently pull the saw stand upwards by the handle (6).
Open the locking mechanism .
This retracts the lock bolts which lock the wheels.
Place one foot on the foot support (14) and push the handle (6) downwards with both hands until the lock bolts can engage again on the other side of the stop plates (21).
Close both the locking mechanism (3) and the locking mechanism (9).

The height-adjustable feet (7) will help you to straighten the saw stand.

To unlock the holder set (1), press the button (23) and open the lever (24).
Place the holder set on the saw stand (2) and push it up to the red stop (25).
Lock the lever (24) again. This ensures that the holder set is firmly positioned on the saw stand.
Measure the distance x between the assembly holes on your power tool.
Unlock the second holder set and position it at a suitable distance x from the holder set that has already been positioned.
Lock the lever (24) again.

Bring the power tool into the transport position. Information about the transport position can be found in the operating instructions for the corresponding power tool.
Position the movable nuts (26) in the holder sets so that they match the assembly holes on the power tool.
Screw together the holder set and power tool using the compatible washers and screws.

Setting up the saw stand (see figure F)