Assembling the Mobile Base Unit

For easier orientation, the wheels are marked ("R" for right-hand wheel, "L" for left-hand wheel).

Note: Do not over-tighten the nuts. The screwed-together parts must be able to move freely.

Ensure that the support frame (18) is installed in the correct direction, as indicated by the "R" and "L" markings that match the wheels.

Note: Do not over-tighten the nuts. The screwed-together parts must be able to move freely.

In this assembly step, the saw stand (2) is screwed to the support frame (18) and the support for the upper frame (13).

  • Turn both supports so that the holes in the sides of the supports point towards the handle.
  • While screwing the saw stand together, ensure that the support (8) is always in the holder on the lower frame (17).

Note: Only tighten the nuts slightly at first. Once all eight screws are positioned correctly, fully tighten all the nuts.

Note: Do not over-tighten the nuts. The screwed-together parts must be able to move freely.