Preparing the workpiece supportThe free end of long workpieces must have something placed underneath it or be supported.Adjusting the height of the workpiece support (see figure I)Place your workpiece on the saw table for the power tool.Loosen the locking knob (10) and adjust the height of the workpiece support (12)so that your workpiece lies flat.Re-tighten this locking knob.Extending the saw stand (see figure J)The saw stand can be extended on both sides.Place your long workpiece on the saw table for the power tool.If necessary, loosen the corresponding locking knob (4) and pull the table extension (5) outwards until it reaches the required length.Re-tighten this locking knob.Sawing workpieces of the same length (see figure K)The length stop (11) can be used for easily sawing workpieces of the same length.Pull the length stop all the way upwards and position the workpiece support at the required distance from the power tool saw blade.