Adjusting bevel angles

Setting the Complete Bevel Angle Range (see figure J)

The bevel angle can be set between 47° (left side) and 47° (right side).

• Pull the stop (44) all the way forward.
  This enables you to use the complete bevel angle range (left and right).
• Pull the right-hand adjustable fence (15) all the way out or remove it completely .
  If you want to use the entire bevel angle range, you also have to pull the left-hand adjustable fence (15) all the way out or remove it completely.
• Loosen the clamping lever (41).
• Swivel the tool arm left or right by the handle (9) until the angle indicator (42)/(31) shows the required bevel angle.
• Retighten the clamping lever (41).

Setting Standard Bevel Angles (see figure K)

For quick and precise setting of frequently used bevel angles, stops have been provided for the angles 0°, 45°, 22.5° and 33.9°.

• Standard 0° bevel angles:
  Swing the tool arm by the handle (9) slightly to the left and swing the stop (44) all the way back.
  Standard 45°, 33.9° and 22.5° bevel angles:
  Turn the left-hand or right-hand stop (29) until the required standard bevel angle engages at the arrow mark.