Practical Advice
Shortly before the cordless worklight switches off because of an empty battery, it will flash three times and shine with reduced brightness.
Errors – causes and corrective measures
Cause | Corrective measure |
|---|---|
A Bluetooth® connection cannot be established with the cordless worklight. | |
The cordless worklight is not emitting a Bluetooth® signal. | Remove the coin cell (12) and rechargeable battery (8) for 10 seconds. |
The cordless worklight cannot be operated via Bluetooth® even though the battery is inserted and charged. | |
The Bluetooth® module is not activated. | Press the on/off switch (7) repeatedly until the cordless worklight can be operated via Bluetooth®. |
The cordless worklight cannot be switched on after wireless charging. | |
The inductively chargeable battery has to be re-initialised. | Remove the rechargeable battery (8) for 10 seconds. |
The PIN for the Bluetooth® connection is not working. | |
The PIN must be reset to factory settings. | Remove the coin cell (12) and rechargeable battery (8) for 10 seconds. |