Adjusting the Guide (see figure H)

In freehand operation (with the exception of sawing close to walls), always use the guide (12) to ensure safe and precise cuts.

Adjust the length of the guide to the relevant cut. To do this, loosen the two screws (21) on the guide using the hex key (9). Pull the guide out (12) as far as required.

For sawing close to walls, sawing in a fixed position and when transporting and storing the power tool, if applicable, push the guide (12) back as far as it will go.

Re-tighten the two screws (21) using the hex key (9).