Inserting/changing the circular saw blade

You will find an overview of recommended saw blades at the end of these operating instructions.

Set the maximum cutting depth, see Setting the cutting depth (see figure C).

To change tools, we recommend that you place the power tool down on the battery side.

• Flip the lever (3) forwards.
• Slide the lock-off switch (2) forwards and press the saw into the base plate (8) until this engages in the position for the saw blade change.
• Press and hold the spindle lock button (28).

• Do not press the spindle lock button (28) while the saw spindle is moving. The power tool may become damaged if this happens.

• Use the hex key (9) to undo the clamping bolt (23) in rotational direction ➋.
• Remove the clamping flange (24) and the saw blade (25) from the saw spindle (27).

Set the maximum cutting depth, see Setting the cutting depth (see figure C).

To change tools, we recommend that you place the power tool down on the battery side.

• Flip the lever (3) forwards.
• Slide the lock-off switch (2) forwards and press the saw into the base plate (8) until this locks into the position for changing the saw blade.
• Clean the saw blade (25) and all the clamping elements to be fitted.
• Place the saw blade (25) on the mounting flange (26). The cutting direction of the teeth (direction of the arrow on the saw blade) must match the rotational direction of the arrow on the protective guard (15).
• Attach the clamping flange (24) and screw in the clamping bolt (23) in rotational direction ➌. Ensure that the mounting flange (26) and clamping flange (24) are installed in the correct position.
• Press and hold the spindle lock button (28).
• Use the hex key (9) to tighten the clamping bolt (23) in rotational direction ➌. The tightening torque should be 6–9 Nm, which corresponds to hand-tight plus ¼ turn.
• Flip the lever (3) back. In doing so, the saw will automatically spring back to its home position.